MAC TOOLS MW250 Betriebsanleitung PDF herunterladen (Seite 156)

100

101

TM 5-4310-452-14

4-49. CONTROL PANEL REPLACEMENT (Con't).

3. Remove access door (7) and hinge (6) from control panel (2).

4. Using electric drill and 1/8 in. twist drill bit, remove 7 rivets (4) from housing (3) and control panel (2).

5. Remove control panel (2) from housing (3). Discard rivets (4).

NOTE

Perform step 6 only if access door or hinge is damaged,

6. Using electric drill and 1/8 in. twist drill bit, remove 2 rivets (8) from hinge (6) and access door (7), Discard damaged

part and rivets.

b. INSTALLATION

NOTE

Perform step 1 only if hinge or access door is new.

1. Position hinge (6) on access door (7). Using rivet gun, install 2 new rivets (8).

2. Position control panel (2) in place in housing (3). Using rivet gun, install 7 new rivets (4),

3. Position hinge (6) and access door (7) in place on control panel (2). Using rivet gun, install 3 new rivets (5)

4. Install identification marker (1) in control panel (2).

4-94

1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 404 405

Kommentare zu diesen Handbüchern

Keine Kommentare

MAC TOOLS MW250 Betriebsanleitung Seite 156

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schweißsystem MAC TOOLS MW250