MAC TOOLS MW250 Betriebsanleitung PDF herunterladen (Seite 345)

TM 5-4310-452-14

5-32. AIR COMPRESSOR HOUSING REPLACEMENT.

This Task Covers:

a. Removal b. installation

Initial Setup:

Equipment Conditions: Materials/Parts:

• Battery cables disconnected (see paragraph • One grommet

4-57).

• Fuel tank removed (see paragraph 4-23), Tools/Test Equipment:

• Oil separator removed (see paragraph 4-88). • General mechanic's tool kit

• Engine removed (see paragraph 5-5).

• Baffles and oil cooler removed (see para- Personnel Required: Two

graph 5-27).

• Slave receptacle removed (see paragraph 4-60).

• Roof side support and doorstops removed (see

paragraph 5-34).

a. REMOVAL

1. Remove 12 screws (11) and accessories storage box (1) from air compressor housing (3).

2. Remove 44 screws (11), 6 screws (8), and nuts (6) from tool box (10), dividers (7 and 9), and engine shield (4).

3. Remove tool box (10), dividers (7 and 9), and engine shield (4) from air compressor housing (3).

4. Remove 18 screws (12) and rear belly pan (5) from air compressor housing (3).

5. Remove 14 screws (12) and front belly pan (16) from air compressor housing (3).

6. Remove 3 studs (13), retainers (15), spring nuts (17), and drain cover (14) from front belly pan (16).

7. Remove grommet (2) from air compressor housing (3). Discard grommet.

8. Remove 12 capscrews (19) and nuts (18) from air compressor housing (3) and frame. Remove air compressor

housing.

b. INSTALLATION

1. Position air compressor housing (3) in place on frame and install 12 capscrews (19) and nuts (18).

2. Install new grommet (2) in air compressor housing (3).

3. Install drain cover (14) on front belly pan (16) with 3 studs (13), retainers (15), and spring nuts (17).

4. Install front belly pan (16) on air compressor housing (3) with 14 screws (12).

5. Install rear belly pan (5) on air compressor housing (3) with 18 screws (12).

6. Install accessories storage box (1) on air compressor housing (3) with 12 screws (11).

7. Install tool box (10), dividers (7 and 9), and engine shield (4) on air compressor housing (3) with 44 screws (11),

6 screws (8), and nuts (6).

5-74

1 2 ... 340 341 342 343 344 345 346 347 348 349 350 ... 404 405

MAC TOOLS MW250 Betriebsanleitung Seite 345