MAC TOOLS MW250 Betriebsanleitung PDF herunterladen (Seite 294)

100

101

TM 5-4310-452-14

5-8. CYLINDER REPLACEMENT (Con't).

NOTE

• If cylinder is new, perform steps 5 through 10.

• If cylinder is not new, go to step 11.

5. Place a piece of 0.08 in. (2 mm) lead wire, cut to full width of piston crown, on piston crown at right angle to engine

center line.

6. Install cylinder head (see paragraph 5-7).

7. Using 36 mm socket and breaker bar, turn crankshaft one complete revolution.

8. Remove cylinder head (see paragraph 5-7).

9. Measure both ends of lead wire with micrometer.

The average compressed thickness of lead wire

must be 0.040-0.047 in. (1.0-1.2 mm).

10. Add or remove shims (2) and spacer rings (3) as

required to meet dimensions in step 9. Repeat

steps 5 through 10 until dimension is correct.

11. Install cylinder head (see paragraph 5-7).

FOLLOW-ON TASKS:

• Connect battery cables (see paragraph 4-57).

• Close left and right door assemblies.

5-22

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 404 405

Kommentare zu diesen Handbüchern

Keine Kommentare

MAC TOOLS MW250 Betriebsanleitung Seite 294

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Schweißsystem MAC TOOLS MW250